UDCAP VR GLOVES DOCUMENT
English
English
  • Udcap VRGlove Product Manual V0.1
  • Product Unboxing
    • Product List
  • Hardware Setup
    • Wearing & Removing the Gloves
    • Peripheral Installation Guide
    • Other (Adapter 3D print file)
    • Glove Charging Instructions
  • Software Setup
    • Software Installation & Update Log
    • Software Overview
    • Firmware Update & Channel Switching
    • SteamVR Settings
    • Lighthouse Tracking Plan: SteamVR and Glove Settings (e.g., VIVE PRO 2)
    • Meta Quest Headsets: Controller Tracking Plan Settings
    • Mixed VR Setup Guide (Inside-Out HMD + Lighthouse Tracking)​
    • Mixed VR Setup Guide (Inside-Out HMD + HTC VIVE Ultimate Trackers)​
    • VRChat Setting
    • SteamVR Input Remapping Tutorial
    • Washing and dismantling tutorial
  • UDCAP VR Gloves FAQs
  • UDEXREAL UDCAP VRGlove LIMITED WARRANTY
Powered by GitBook
On this page
  1. Software Setup

Washing and dismantling tutorial

PreviousSteamVR Input Remapping TutorialNextUDCAP VR Gloves FAQs

Last updated 3 months ago

The bottom of the data box has screw holes in the corners.

Note: After unscrewing the four base screws, there are data cables connected to the circuit board in the top cover. Please do not take down the top cover forcefully!

Gently flick the snap upwards. This will disconnect the glove from the board.

Glove washing precautions：

  1. Prohibit the use of corrosive washing solvents to clean the gloves.

  2. Prohibit the use of washing machines, dryers, etc.

  3. Do not pull, twist, or turn the gloves by force during hand washing.

  4. Do not expose gloves to direct sunlight. They should be left to dry naturally in a cool place.

  5. Do not soak the gloves for a long time.

  6. Avoid drastic and rapid changes in the temperature of the water used in the cleaning process.

  7. Wash gloves at a temperature of 25℃.